Page #5 [ Previous ] [ Next  ] [ Contents ] [ Timesaver Home Page ]
Timesaver Mold Base® advantages

DESIGN TIME

One of the basic ideas in developing the Timesaver Mold Base® is to save you valuable design time. You can have the mold base in-house even before the mold design is completed. Also for your configuration needs, you can interchange the stationary and the ejection halves between pocket and bore style timersavers.

LEAD TIME

A finished mold base is the longest lead time component in your mold making process. A Timesaver Mold Base ® shortens that lead time They are on the shelf with pre-finished pockets or bores, guided ejection, knock outs, eye-bolts, and pry slots. Shortening lead times earns you a hero badge with your customer.

MANUFACTURING TIME

Consider the time saved not having to finish pockets or bores, install the ejector guides, knock outs, eyebolts, and pry slots. Typically, all you need to add to your Timesaver Mold Base ® are the ejector pins, water lines on pocket bases, and, if needed, support posts.

Look at what the TIMESAVER ® offers you

  1. Finished Pockets or Bores,
  2. Water Lines on Timesaver Bore bases ®
  3. Guided Ejection
  4. Knock Out Holes with tapped Ejector Plates
  5. Eye-bolts
  6. Pry Slots
  7. Bronze Bushings
  8. 4130 Steel or Stainless Steel
  9. Twenty Mold Base Combinations
  10. Available in Three Sizes 7-7/8 x 7-7/8, 11-7/8 x 12, 14 x 16
Precision Mold Base Corporation
2405 W. Geneva Dr.
Tempe, AZ, 85282-3125
National Phone 800 - 228 - 7622, Fax 800 - 722 - 7622
Arizona Phone 602 - 431 - 8131, Fax 602 - 431 - 8171
Web Site http://www.pmbc.com E-mail info@pmbc.com

® TIMESAVER MOLD BASES is a registered trademark of Precision Mold Base Corporation
© CopyrightPrecision Mold Base Corporation 2000

Page #5 [ Previous ] [ Next  ] [ Contents ] [ Timesaver Home Page ]
Our complete Timesaver ® manual in Word97 DOC format [Word Link Button] File Size = 936 KB
Our complete Timesaver ® manual in Acrobat PFD format [Acrobat Link Button] File Size = 2.8 MB