Precision Mold Base Corporation
TIMESAVER MOLD BASE ®
SERIES
1P08 BASES: 7-7/8 X 7-7/8 "B"
SERIES MOLD BASE
Part NumberGuided Ejection = .750 Diameter ( 2 places )Clamp Type Locating Ring installed
Standard 1 " Diameter Sprue Bushing included
.250 Diameter Sprue puller pin included
½-13 eyebolt holes, 2 in Hot Half & 2 in Ejector Half
Press Knock-out holes, 2 places - 3.500 off center
With ½-13 tapped holes in the Ejector plate
1P082333
A Plate = 2.375, Pocket Depth = 1.000
B Plate = 3.375, Pocket Depth = 2.000
1P083323
A Plate = 3.375, Pocket Depth = 2.000
B Plate = 2.375, Pocket Depth = 1.000
1P083333
A Plate = 3.375, Pocket Depth = 2.000
B Plate = 3.375, Pocket Depth = 2.000
A plate = 2.375 B plate = 1.875 Leader Pin Length = 5.25
2B082318
Two Cavity
2.375 Through Bore .50 Long
2.500 Step
2.750 C'Bore .3125 deep
4B082318
Four Cavity
1.875 Through Bore .50 Long
2.000 Step
2.1875 C'Bore .250 deep
8B082318
Eight Cavity
.9375 Through Bore .50 Long
1.000 Step
1.1875 C'Bore .250 deep
HOW TO READ PART NUMBERS
1P 12 28 38
_ _ _ _
Style 1P = Pocket, 2B = Bore, etc.._| | | |
Length of Base____________________________| | |
Thickness of A-Plate____________________________| |
Thickness of B-Plate__________________________________|
Precision Mold Base Corporation ® TIMESAVER MOLD
BASES is a registered trademark of Precision Mold Base Corporation
©
CopyrightPrecision Mold Base
Corporation 2000