Page 7, Timesaver Design Manual, Assembly Dimentions, 7-7/8 x 7-7/8

7-7/8 X 7-7/8 "A" & "B" Series TIMESAVER MOLD BASE ®

Assembly Dimensions

Assembly Image of 7-7/8 x 7-7/8 Timeasvers

7-7/8 X 7-7/8 "A" & "B" SERIES MOLD BASE

Guided Ejection = .750 Diameter ( 2 places )

Clamp Type Locating Ring installed

Standard 1 " Diameter Sprue Bushing included

.250 Diameter Sprue puller pin included

½-13 eyebolt holes, 2 in Hot Half & 2 in Ejector Half

Press Knock-out holes, 2 places - 3.500 off center

With ½-13 tapped holes in the Ejector plate

"C" height = 3.500

Ejection stroke = 1.8125

Precision Mold Base Corporation
2405 W. Geneva Dr.
Tempe, AZ, 85282-3125
National Phone 800 - 228 - 7622, Fax 800 - 722 - 7622
Arizona Phone 602 - 431 - 8131, Fax 602 - 431 - 8171
Web Site http://www.pmbc.com E-mail info@pmbc.com